Dometic RM2811 Manuale Utente Pagina 2

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 10
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 1
2. GAS SUPPLY
The refrigerator requires 11 inches water column with half
of all the BTUs of the RV turned on (half of all
aDubances
turned on). With all the appliances off, the pressure to the
refrigerator should not exceed 12 inches water column.
The gas pressure for the refrigerator is taken at the test port
after the solenoid with the refrigerator operating. See FIG.
2
&
2A.
C.
FIG. 2
SlLHOUETTE
THERMOCOUPLE
I
I
FIG. 2A
DOMETIC
SOLENOID VALVE
BURNER WITH
THERMOCOUPLE
Board
3. COMPONENTS
The Reignitor
is an electronic device that pro-
duces high voltage to create a spark to ignite a
flame at the burner, when refrigerator operates on
LP gas.
Verify proper DC power is at the positive (+) and
ground (-) terminals. The reading should be within
one volt of the voltage at the main terminal block
during the trial-for-ignition. (See Item 4, Grounds,
Paragraph E).
The reignitor installed on the refrigerators as
original equipment is part number 2931132019
(RV Gas Model 679). This reignitor is rated 50
MA. This reignitor may also be used on any other
model.
DO NOT
install the Channel Mark 6, Model
12E
Reignitor (shown below) as a service replace-
ment part. (FIG. 3 & 3A).
FIG.
3
A.
B.
The Thermocouple
is a component that extends
over three slots on the burner assembly so its tip
is in the path of the flame. During normal gas
operation, the thermocouple should produce 25 to
30 millivolts when connected to the lower circuit
board. Any reading below 18 millivolts
could
cause
erratic gas operation. NOTE: A reading of 18 or
less could be caused by low gas pressure or
improper thermocouple location.The thermocouple
should be centered over the burner and extend over
3 slots. See FIG. 2
&
2A.
The Burner
is a horizontal slotted metal tube
located below the flue tube of the cooling unit. The
burner should be cleaned periodically (at least
once a year). To clean the burner, remove from
the refrigerator and check for any foreign residue
(rust, spider webs, etc.) that could cause a deflec-
tion of the gas flow or flame. Soak the burner in an
alcohol based solvent and allow to air dry.
Rein-
stall in refrigerator and leak check all gas connec-
tions with an approved leak check solution. See
GASLllER
MARK 6, MODEL
12E
W/O 1282150 9318
FIG. 2
&
2A.
2
12VDC
25mA
CHANNEL PRODUCTS
CHESTERLAND
OH 44026
Manual Compliments of
Northwest RV Supply
Printed From
http://www.nwrvsupply.com
Vedere la pagina 1
1 2 3 4 5 6 7 8 9 10

Commenti su questo manuale

Nessun commento