Has the defrosting button been inadvertently
pushed in? (only for semi-automatic defrost)
If, so turn the thermostat dial to "0" and the
defrosting button will be released. Reset the dial
to its usual position and the refrigerator should
start cool again.
Has the ventilation become obstructed?
When checking all the above points, the
refrigerator is still not working satisfactorily, contact
your nearest service engineer. State the problem,
model, product- and serial-number.
(Details of the model, product- and serialnumber
are to be found on the data label in the top left of
the inside compartment.)
This refrigerator is equipped with overheating
protection. An authorised service engineer can
check whether this has been triggered or not.
In the event of a fault developing, contact your
nearest Service Centre-see local telephone
directory.
13. Putting into operation
Technical data:
13.1. Connecting to electrical mains
The appliance may only be operated from
nominal voltage mains as shown on the data
plate. The appliance mains plug may be connected
to a mains socket earthed in accordance with
regulations.
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
The manufacturer declines any liability should
these safety measures not be observed.
Electrical Requirements
Before switching on, make sure the electricity
supply voltage is the same as that indicated on the
appliance rating plate.
Only for UK:
The appliance is supplied with a 3 amp plug fitted.
In the event of having to change the fuse in the plug
supplied, a 3 amp ASTA approved (BS 1362) fuse
must be used. Should the plug need to be replaced
for any reason, the wires in the mains lead are
coloured in accordance with the following code:
7
edge of the frame. A new panel can be inserted more
easily into the upper edge of the frame when the two
corners are cut off by approx. 5 x 5 mm (8). Put the
frame edge (5) back in place and secure with screws.
Figure 9.
Place the door on the lower hinge (9), slot the upper
hinge into the opening, press together with the door
against the housing and secure with the two screws
(11).
Figure 10.
11. Assembly of door handle (Fig. 11.)
Figure 11.
12. Customer service
Before you call a service engineer, carry out the
following simple tests:
Is there a power failure? Check the fuses.
Is the plug firmly connected to the socket and is the
socket switched on? Check the socket by plugging
in another appliance, e.g. a table lamp.
Is the thermostat at the correct setting? (normally 3
or 4).
Has the door not been closed properly causing the
inside temperature to rise too quickly?
Is the refrigerator level?
Model EA 0610
Type MF 20-60
Gross volume 60 litre
Mains operation 230V (AC)
Input 115W
Energy consumption 1.3 kWh/24h
Climate class N
Refrigerant 357g H
2
O+168g NH
3
Commenti su questo manuale