Dometic RM760 Manuale Utente Scaricare il pdf (Pagina 3)

RV Refrigerator Cooling Unit Removal and Installation Instructions

Please carefully review these instructions, along with the Troubleshooting document on our Web site,

when troubleshooting, removing or installing any cooling unit.

Removal Instructions

1. Turn off the propane.

a. Light the stovetop burner to burn off any propane left in the gas line.

b. Turn off the burner when the ﬂ ame dies.

2. Disconnect the 12-volt DC power supply at the back of the refrigerator.

a. Tape off exposed wires with electrical tape.

3. Disconnect the propane line from the refrigerator.

a. Always use two wrenches when disconnecting the line. This will support the other ﬁ ttings and prevent damage to them.

b. If the propane is turned on to the rest of the coach before the refrigerator is re-installed, plug the line to the refrigerator

with the proper ﬁ tting and check for leaks with soapy water.

4. Unplug the 110-volt AC power cord.

a. Make sure the cord is not wrapped around anything, and then tuck the cord into the absorber (large coiled tubes).

5. Remove the two mounting screws or bolts (the type of fastener will differ by model) that hold the back of the refrigerator to

the cabinet.

6. Remove the door(s).

a. Remove the top plastic trim (eyebrow) of the refrigerator.

b. Remove all hinge pins and take off door(s).

c. Remove the four to six plastic screw covers and the screws behind them.

7. Silicone is often used to seal the bottom edge of the refrigerator.

a. Cutting the silicone with a razor knife will make the refrigerator removal easier and won’t rip the paneling.

8. Carefully push and pull the refrigerator until it slides out from the cabinet.

a. If possible, remove the refrigerator from the RV to continue with disassembly.

9. In the freezer compartment, remove all the screws that go through the back wall or into the freezer shelf.

a. Remove any freezer shelf and trim pieces.

10. Detach the thermistor or capillary tube from the ﬁ ns inside the refrigerator compartment.

a. Some models will need to have it carefully removed from the refrigerator compartment. Dometic models RM 760, 761,

763, 1300, 1301 and 1303 have the capillary tube entering the back left of the refrigerator through a hollow sleeve. Pull

the capillary tube out of the hollow sleeve and carefully tuck it out of the way of the cooling unit.

b. These parts can add time and expense if you’re not careful in handling them. Capillary tubes are hollow; if they break,

you need to replace the entire thermostat.

11. Remove all screws from the refrigerator ﬁ n assembly.

a. If the screw heads start to strip, lay the refrigerator on its back so added pressure can be applied to the screws. This prob-

lem is most common with Norcold refrigerators.

ATCO

GALVANIZED



800.227.3180

ATCO America RV refrigerator cooling unit instructions —provided as a service to our dealers

based on our years of experience supporting RV service technicians.

www.atcoamerica.com

Removal and Istallation

Page 3

1 2 3 4 5 6

ATCO 1

Commenti su questo manuale

Nessun commento

Dometic RM760 Manuale Utente Pagina 3

Commenti su questo manuale

Prodotti e manuali riguardandi no Dometic RM760